TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 187 of 1555
TM 9-2320-387-24-2 1 O-92. SOFT TOP DOOR ADJUSTMENT This taskcovers: Adiustment INITIAL SETUP: ApplicableModels Ml113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 11 Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-2413 Maintenance Level unit Adjustment 1. Open and close door (11 to check fit of door seal (2) to body (3). Door seal (2) should lit inside and contact door outline on body (3). 2. For vertical and horizontal adjustment of door (11, loosen four screws (4) on two hinges (5) and door (1). Slide door (1) to fit door outline on body (3). Hold door (1) in position, and tighten four screws (4) on two door hinges (5) and door (1). NOTE If additional vertical adjustment is needed, follow step 3. If no additional vertical adjustment is needed, go to step 4. 3. For additional vertical adjustment of door (11, remove door (1) from body (31 (TM 9-2320-387-10). Loosen four capscrews (7) on two body hinge mounts (6) and body (3) and slide body hinge mounts (6) up or down for adjustment. Hold body hinge mounts (6) in position, and tighten four capscrews (7) to 8 lb-R (11 N-m). Install door (1) (TM 9-2320-387-10). 4. For in and out adjustment of door (11, loosen two capscrews (8) on striker (10) and B-pillar (11). With door (1) closed and door seal (21 pressed against body (31, slide striker (101 against inner door handle latch (9) and tighten two capscrews (81. Open door (11 and tighten two capscrews (81 to 15 lb-R (20 Nom). 5. Close door (11 and check for fit of door seal (2) to door outline on body (3) and inner door handle latch (9) operation. Readjust door (1) if necessary. 10-154