TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 155 of 1555
TM 9-2320-387-24-2 I 1O-71. HEATER OUTLET/INLET PIPING MAINTENANCE 1 This task covers: a. Removal b. Inspection c. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Manual References EquipmentCondition Cooling system drained as required (para. 3-61). Maintenance Level Unit TM 9-2320-387-10 TM 9-2320-387-24P NOTE Replacement procedures for inlet and outlet piping are basically the same. This procedure covers the outlet piping. Ixxzz-) 1. Loosen clamp (9) and disconnect heater outlet hose (10) from water pump nipple (8). 2. Remove nut (121, washer (71, capscrew (61, and washer (7) from inlet hose clamp (5) and outlet hose clamp (13). 3. Loosen clamp (2) and remove heater outlet hoses (3) and (10) and heater outlet tube (11) from heater outlet port (1) and vehicle. 4. Loosen two clamps (4) and remove heater outlet hoses (3) and (10) from heater outlet tube (11). 5. Remove clamps (21, (41, (131, and (9) from hoses (3) and (10). 1 b. Inspection 1 Inspect heater outlet port (1) and water pump nipple (8). Replace if damaged. c. Installation 1. Install clamps (21, (41, (13), and (9) on hoses (3) and (10). 2. Install two heater outlet hoses (3) and (10) on heater outlet tube (11) and tighten two clamps (4). 3. Install heater outlet hoses (3) and (10) and heater outlet tube (11) on heater outlet port (1) and water pump nipple (8) and tighten clamps (2) and (9). 4. Install outlet hose clamp (13) on inlet hose clamp (5) with washer (71, capscrew (61, washer (71, and nut (12). 10-122