TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1467 of 1555
TM 9-2320-387-24-2 D-84.6 Change 1 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) MATERIAL BLOCK STOCK SIZE DESCRIPTION SPECIFICATION 0.125 X 2.570 X 3.500 in. ALUMINUM FLAT SHEET IAW ASTM B 209 (3.175 X 65.278 X 88.900 mm) 0.125 X 0.750 X 24.000 in. ALUMINUM RECTANGLE IAW ASTM B 211 (3.175 X 19.050 X 609.600 mm) Figure D-107. Pulley Alignment Tool Fabrication. INSTRUCTIONS: NOTE • Remove all burrs and sharp edges from aluminum sheet and rectangle. • Pulley alignment tool can be assembled using nuts, bolts, rivets, or by welding. 1. Cut aluminum sheet (1) to size as shown. 2. Position aluminum rectangle (2) on top of aluminum sheet (1) as shown in figure D-107. NOTE Check all measurements before welding, riveting, or bolting pulley alignment tool together. 3. Assemble pulley alignment tool as shown in figure D-107. 0.500 in. (12.700 mm) 2.070 in. (52.578 mm) 0.500 in. (12.700 mm) 0.750 in. (19.050 mm) 0.125 in. (3.175 mm) 24.000 in. (609.600 mm) 3.500 in. (88.900 mm) 2.570 in. (65.278 mm) 0.125 in. (3.175 mm)