TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 143 of 1555
10-65. WINDSHIELD WASHER HOSES REPLACEMENT INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Sealing compound (Appendix C, Item 72.1) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Hood raised and secured (TM 9-2320-387-10). Maintenance Level Unit This task covers: a. Removal b. Installation 1. Remove nut (18), washer (4), capscrew (5), washer (4), clamp (3), and washer hose (1) from body (14). 2. Remove two nuts (12), washers (11), capscrews (16), washers (11), clamps (10), and washer hose (13) from body (14). 3. Disconnect washer hose (13) from pump (15) and tee (6), and remove through clamps (17). NOTE Perform steps 4 and 5 for M1114 models only. Perform steps 6 and 7 for M1113 models only. 4. Remove two screws (19), clamps (21), and nozzles (20) from body (14). 5. Remove washer hoses (1) and (8) from nozzles (20). 6. Remove clamp (7) and washer hose (8) from tee (6) and nozzle (9). 7. Remove clamp (7) and washer hose (1) from tee (6) and nozzle (2). 8. Remove washer hoses (8) and (1) through clamps (17). NOTE Perform steps 1 and 2 for M1113 models only. Perform steps 3 and 4 for M1114 models only. 1. Install washer hose (1) through clamps (17) and connect to nozzle (2) and tee (6). 2. Install washer hose (8) through clamps (17) and connect to nozzle (9) and tee (6). 3. Install two nozzles (20) on washer hoses (1) and (8). 4. Apply sealing compound to screws (19) and install washer hoses (1) and (8) and two nozzles (20) on body (14) with two clamps (21) and screws (19). Tighten screws (19) to 35 lb-in (4 N•m). 5. Install washer hose (13) through clamps (17) and connect to tee (6) and pump (15). NOTE When installing clamps, ensure they are positioned below hood rest, so hood does not interfere with clamps or hose when lowered. 6. Install clamp (3) on washer hose (1) and body (14) with washer (4), capscrew (5), washer (4), and nut (18). 7. Install two clamps (10) on washer hose (13) and body (14) with two washers (11), capscrews (16), washers (11), and nuts (12). b. Installation a. Removal TM 9-2320-387-24-2 10-110 Change 1