TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 139 of 1555
TM 9-2320-387-24-2 1 1 O-63. WINDSHIELD WIPER SWITCH/MOTdR REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two lockwashers (Appendix G, Item 221) Lockwasher (Appendix G, Item 222) Manual References TM 9-2320-387-10 TM 9-2320-387-24P. Equipment Condition Battery ground cables disconnected (para. 4-68). Maintenance Level Unit 1 a. Removal 1 . 1. 2. 3. 4. 5. 6. 7. 8. NOTE Perform steps 1 through 5 for removal of wiper motor switch. Proceed to step 6 for removal of wiper motor assembly. Disconnect lead (12) from wiper switch (11). Depress retaining clip on back of knob (15) and remove knob (15) from wiper switch (11). Remove nut (14) and lockwasher (13) from wiper switch (11) and wiper motor mounting plate (10). Discard lockwasher (13). Disconnect switch connector (9) from wiper motor (5) and remove wiper switch (11). Remove screw (161, lockwasher (171, ground lead 57G (181, wiper switch ground lead (61, and lockwasher (19) from wiper motor mounting plate (10). Discard lockwashers (17) and (19). Remove three capscrews (8) and washers (7) from wiper motor (5) and windshield frame (1). Pull wiper motor (5) away from windshield frame (1) for access to clip (2). Remove clip (2) and connecting arms (3) from wiper motor shaft (4) and remove wiper motor shaft (4) from windshield frame (1). b. Installation NOTE Perform steps 1 through 5 for installation of wiper motor switch. Proceed to step 6 for installation of wiper motor assembly. 1. Install wiper switch (11) on wiper motor mounting plate (10) with lockwasher (13) and nut (14). 2. Depress retaining clip on back of knob (15) and install knob (15) on wiper switch (11). 3. Connect switch connector (9) to wiper motor (5). 4. Connect lead (12) to wiper switch (11). > 5. Install lockwasher (191, wiper switch ground lead (61, and ground lead 57G (18) on wiper motor mounting plate (10) with lockwasher (17) and screw (16). 6. Position wiper motor (5) in windshield frame (1) and connecting arms (3) on wiper motor shaft (4) with clip (2). 7. Install wiper motor (5) on windshield frame (1) with three washers (7) and capscrews (8). 10-106