TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 136 of 1555
TM 9-2320-387-24-2 Change 1 10-103 1. Remove two access covers (7) (M1113), or eight capscrews (8), lockwashers (8.1), washers (8.2), and two plates (9) (M1114), from windshield frame (1). Discard lockwashers (8.1). 2. Pull connector arm retainer (3) from ball stud (5) and remove motor drive lever (6) from connector arm (4). 3. Disconnect connector arm (4) from wiper arm pivots (2) and remove connector arm (4) through center access in windshield frame (1). CAUTION Install left (driver’s) side connector arm first, or damage to equipment will result. 1. Install connector arm (4) through center access on windshield frame (1) and connect connector arm (4) to wiper arm pivots (2). 2. Connect connector arm (4) together with motor drive lever (6) and connector arm retainer (3) on ball stud (5). 3. Install two access covers (7) (M1113), or two plates (9) with eight washers (8.2), lockwashers (8.1), and capscrews (8) (M1114), on windshield frame (1). Tighten capscrews (8) to 75 lb-in. (9 N•m). b. Installation a. Removal 10-61. WINDSHIELD WIPER LINKAGE REPLACEMENT This task covers: a. Removal b. Installation Manual References TM 9-2320-387-24P Equipment Condition Windshield wiper motor removed (para. 10-63). Maintenance Level Unit INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Eight lockwashers (Appendix G, Item 207) FOLLOW-ON TASK: Install windshield wiper motor (para. 10-63). 9 M1114 3 5 6 4 7 2 8.1 1 8.2 8