TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1321 of 1555
33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d) TM 9-2320-387-24-2 33-92 Change 1 1. Cut two metal strips (1) from sheet metal, and mark two reference lines (2), centerline (3), and directional arrow (4), and identify as metal strips C and D. 2. Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip C (1). 3. Bend metal strip C (1) 1.50-in. (38.10-mm). 4. Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip D (1). 5. Bend metal strip D (1) 1.50-in. (38.10-mm). c. Metal Strips Fabrication METRIC CONVERSION 2.50 IN. 63.50 MM 3.50 IN. 76.20 MM 8.50 IN. 215.90 MM 29.70 IN. 754.38 MM METRIC CONVERSION 0.60 IN. 15.24 MM 0.75 IN. 19.05 MM 1.25 IN. 31.75 MM 1.40 IN. 35.56 MM 1.50 IN. 38.10 MM DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES 29.70