TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1319 of 1555
33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d) TM 9-2320-387-24-2 33-90 Change 1 1. Cut reinforcement strip (1) from sheet metal, and mark four reference lines (2), centerline (3), and identify as A on reinforcement strip (1). 2. Locate, mark, and drill twenty-one 0.187-in. (4.75-mm) diameter holes and a 0.750-in. (19.050-mm) diameter hole through reinforcement strip A (1). 3. Remove all burrs and round sharp edges of reinforcement strip A (1). 4. Cut reinforcement strip (4) from sheet metal, and mark four reference lines (5) and centerline (6). Identify reinforcement strip (1) as B. 5. Locate, mark, and drill eighteen 0.187-in. (4.75-mm) diameter holes and a 0.500-in. (12.700-mm) diameter hole through reinforcement strip B (4). 6. Remove all burrs and round sharp edges of reinforcement strip B (4). b. Reinforcement Strips Fabrication 4.00 0.75 0.75 0.75 0.75 2.00 2.00 2.00 2.00 2.00 DRILL 0.750-IN. (19.050-MM) DIAMETER HOLE DRILL TWENTY-ONE 0.187-IN. (4.75-MM) DIAMETER HOLES 2.00