TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1317 of 1555
33-14. RIGHT REAR FLOOR PANEL REPAIR TM 9-2320-387-24-2 33-88 Change 1 This task covers: a. Right Rear Insert Panel Fabrication g. Metal Strip C and Insert Panel Assembly b. Reinforcement Strips Fabrication h. Metal Strip E and Insert Panel Assembly c. Metal Strips Fabrication i. Metal Strip D and Insert Panel Assembly d. Right Rear Floor Panel Removal j. Right Rear Floor Panel and Insert Panel Drilling e. Reinforcement Strip A and Insert Panel Assembly k. Insert Panel and Right Rear Floor Panel Installation f. Reinforcement Strip B and Insert Panel Assembly 1. Cut insert panel (1) from sheet metal, and mark four reference lines (3) and directional arrow (2) on insert panel (1). 2. Locate, mark, and drill six 0.312-in. (7.925-mm) diameter holes and one 1.00-in. (25.4-mm) diameter hole through insert panel (1). 3. Fabricate two drain holes (4) in insert panel (1). 4. Bend insert panel (1) 1.50-in. (38.10-mm). 5. Remove all burrs and round all sharp edges of insert panel (1). a. Right Rear Insert Panel Fabrication NOTE All dimensions are in inches. For Metric conversion, see chart. INITIAL SETUP: Applicable Models M1113 Tools General mechanic’s tool set automotive (Appendix B, Item 1) Riveter tool kit (Appendix B, Item 123) Shop equipment, automotive maintenance and repair: field maintenace, wheeled vehicles, Post, Camp and Station, set A (Appendix B, Item 10) Manual References TM 9-2320-387-24P TM 43-0139 Materials/Parts Ninety-two rivets (Appendix G, Item 335) Thirty-two rivets (Appendix G, Item 347.2) Adhesive (Appendix C, Item 2.1) Adhesive sealant (Appendix C, Item 7.1) Sheet metal (Appendix G, Item 439.1) Equipment Condition Right rear floor insulation removed (para. 10-34). Maintenance Level General Support METRIC CONVERSION 6.50 IN. 165.10 MM 7.25 IN. 184.15 MM 8.00 IN. 203.20 MM 8.25 IN. 209.55 MM 10.50 IN. 266.70 MM 16.50 IN. 419.10 MM 27.00 IN. 685.80 MM METRIC CONVERSION 0.125 IN. 3.175 MM 0.80 IN. 20.32 MM 1.00 IN. 25.40 MM 1.25 IN. 31.75 MM 1.50 IN. 38.10 MM 2.00 IN. 50.80 MM 4.00 IN. 101.60 MM 4.25 IN. 107.95 MM