TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1301 of 1555
33-13. RIGHT FRONT FLOOR PANEL REPAIR (Cont’d) TM 9-2320-387-24-2 33-72 Change 1 1. Using a 0.187-in. (4.75-mm) drill bit, remove twenty-eight rivets (5) from right front seat support (3), battery tray (4), and right front floor panel (1). 2. Using a 0.187-in. (4.75-mm) drill bit, remove fifteen rivets (5) from battery tray (4) and tunnel (2). 3. Position insert panel (6), with arrow facing down and toward front of vehicle, to underside of right front floor panel (1) and align to battery tray (4). 4. Using insert panel (6) as a template, scribe an outline (8) on right front floor panel (1). NOTE Do not cut through front seat support when removing right front panel section. 5. Using scribed outline (8), cut and remove right front floor panel (1). 6. Remove battery tray (4). 7. Remove sharp edges and burrs on right front floor panel (1). 8. Remove any adhesive residue and clean left front seat support (7) and tunnel (2). 9. Position insert panel (6), with arrow facing down and toward front of vehicle, to underside of right front floor panel (1). 10. Obtain a minimum clearance of 0.10-in. (2.54-mm) between edges of insert panel (6) and right front floor panel (1). 11. Remove insert panel (6). c. Right Front Floor Panel Removal DRILL TWENTY-EIGHT 0.187-IN. (4.75-MM) DIAMETER HOLES THROUGH RIVETS DRILL FIFTEEN 0.187-IN. (4.75-MM) DIAMETER HOLES THROUGH RIVETS 5 3 2 4 ~ 1 ~