TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 129 of 1555
TM 9-2320-387-24-2 10-58.2. UNDERBODY PROTECTION KIT REPLACEMENT (Cont’d) 10-98.14 Change 1 1. Install intermediate shield (6) and front shield (2) on front crossmember (1) with two washers (4), capscrews (5), washers (4), and locknuts (3). Tighten locknuts (3) to 44 lb-ft (60 N•m). 2. Install left side support bracket (14) on left side mounting bracket (15) with four washers (11), capscrews (10), washers (11), and locknuts (16). Do not tighten locknuts (16). 3. Install right side support bracket (24) on right side mounting bracket (22) with four washers (21), capscrews (20), washers (21), and locknuts (23). Do not tighten locknuts (23). 4. Install left side support bracket (14) on engine mount bracket (7) and left side frame rail (13) with washer (9), capscrew (8), washer (9), and locknut (12). Tighten locknut (12) to 105 lb-ft (142 N•m). 5. Install right side support bracket (24) on right side frame rail (25) with washer (18), capscrew (19), washer (18), and locknut (17). Tighten locknut (17) to 105 lb-ft (142 N•m). 6. Install two transmission support brackets (28) on intermediate shield (6) and transmission mount crossmember (31) with four rubber washers (29), six washers (26), capscrews (27), washers (26), and locknuts (30). Tighten locknuts (30) to 30 lb-in. (3 N•m). 7. Tighten locknuts (16) and (23) to 24 lb-ft (33 N•m). j. Intermediate Shield Installation