TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1273 of 1555
33-12. LEFT REAR FLOOR PANEL REPAIR (Cont’d) TM 9-2320-387-24-2 33-44 Change 1 1. Cut two metal strips (2) from sheet metal, and mark two reference lines (1), centerline (3), and directional arrow (4). Identify two metal strips (2) as C and D. 2. Locate, mark, and drill twenty-four 0.187-in. (4.75-mm) diameter holes through metal strips C and D (2). 3. Bend metal strips C and D (2) 1.50 in. (38.10-mm). c. Metal Strips Fabrication DRILL TWENTY-FOUR 0.187-IN. (4.75-MM) DIAMETER HOLES METRIC CONVERSION 0.60 IN. 15.24 MM 0.75 IN. 19.05 MM 1.25 IN. 31.75 MM 1.40 IN. 35.56 MM 1.50 IN. 38.10 MM 2.00 IN. 50.80 MM 2.50 IN. 63.50 MM 3.00 IN. 76.20 MM 8.50 IN. 215.90 MM 32.70 IN. 830.58 MM