TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 125 of 1555
TM 9-2320-387-24-2 10-58.2. UNDERBODY PROTECTION KIT REPLACEMENT (Cont’d) 10-98.10 Change 1 .WARNING. • Fuel tank must be supported during removal. Failure to do so may cause damage to fuel tank or injury to personnel. • Diesel fuel is highly flammable. Do not perform this task near fire, flames, or sparks. Severe injury or death may result. 1. Drain fuel tank (1) (refer to para. 3-25). 2. Remove two locknuts (6), washers (2), capscrews (3), washers (2), and support straps (5) from upper straps (4). Discard locknuts (6). 3. Swing support straps (5) down and remove fuel tank shield (7). .WARNING. • Fuel tank must be supported during installation. Failure to do so may cause damage to fuel tank or injury to personnel. • Diesel fuel is highly flammable. Do not perform this task near fire, flames, or sparks. Severe injury or death may result. 1. Position fuel tank shield (7) on fuel tank (1) and raise support straps (5). NOTE Maintain 0.50-in. (13-mm) clearance between upper and lower straps when tightening locknuts. 2. Install support straps (5) on upper straps (4) with two washers (2), capscrews (3), washers (2), and locknuts (6). Tighten locknuts (6) to 37 lb-ft (50 N•m). 3. Fill fuel tank (1) (refer to TM 9-2320-387-10). g. Fuel Tank Shield Installation f. Fuel Tank Shield Removal