TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1231 of 1555
TM 9-2320-387-24-2 33-2 Change 1 INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Locknut (Appendix G, Item 174) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition • Hood raised and secured (front mounts only) (TM 9-2320-387-10). • Left rear underbody armor removed (M1114 only) (para. 11-37). • Right rear underbody armor removed (M1114 only) (para. 11-39). Maintenance Level General support 1. Remove locknut (2), washer (1), capscrew (7), washer (8), and spacer (9) from sleeve (4), upper cushion (5), lower cushion (10), body bracket (3), and frame bracket (6). Discard locknut (2). 2. Place jack under body reinforcements adjacent to body mount to be removed. 3. Raise body far enough to separate upper cushion (5) from lower cushion (10) and remove sleeve (4), upper cushion (5), and lower cushion (10). b. Installation 1. Install lower cushion (10), upper cushion (5), and sleeve (4) between body bracket (3) and frame bracket (6). 2. Lower body and align lower cushion (10), sleeve (4), upper cushion (5), and body bracket (3) and secure with spacer (9), washer (8), capscrew (7), washer (1), and locknut (2). Tighten locknut (2) to 90 lb-ft (122 N•m). NOTE • Replacement procedures for intermediate and rear body mounts are identical. • On front body mounts, capscrew is inserted down through upper cushion. • This procedure covers left intermediate body mount. a. Removal 33-3. BODY MOUNT REPLACEMENT This task covers: a. Removal b. Installation