TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1212 of 1555
TM9-2320-387-24-2 31-3. STEERING GEAR REPAIR (Cont’d) 18. 19. 20. 21. 22. 23. 24. 25. Install O-ring (16) in valve body (11). Insert worm shaft (14) into valve body (11). Engage locating pin (15) on worm shaft (14) with slot (17) in valve body (111. NOTE Coned surface of races face toward housing. Install lower thrust bearing race (181, lower thrust bearing (131, and lower thrust bearing race (18) on worm shaft (14). Install assembled valve body (11) and worm shaft (14) into housing (12). Install O-ring seal (24), large upper bearing race (231, upper thrust bearing (22), small upper bearing race (21), thrust bearing spacer (201, and bearing retainer (19) on adjuster plug (25). Press retainer (19) onto adjuster plug (25) with a brass drift. Install stub shaft oil seal (26) in adjuster plug (25). Install far enough to provide clearance for dust seal (27) and retaining ring (28). Install stub shaft dust seal (27) and retaining ring (28) in adjuster plug (25). 0 18 31-15