TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1210 of 1555
TM 9-2320-387-24-2 I 31-3. STEERING GEAR REPAIR (Cont’d) I NOTE Keep bearing balls in alternating sequence when installing guide in rack piston. Ensure a total of 24 bearing balls are used. 8. Install eight remaining bearing balls (11) in guide (12) half and retain with grease. 9. Assemble both guide (12) halves together and install guide (12) in guide holes (10). 10. Install clamp (14) over guide (12) with two screw-assembled washers (13). Tighten screw-assembled washers (13) to 4 lb-R 6 N-m). 11. Rotate worm shaft (9) clockwise until flush with rack piston (8). 12. Install rack piston arbor into rack piston (8) and hold firmly against worm shaft (9). Remove worm shaft (9). 7 I 1 RACK FIST-ON ARBOR 31-13