TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 119 of 1555
1. Remove three locknuts (9), washers (2), capscrews (7), washers (2), and front skid plate (6) from front shield (8). Discard locknuts (9). 2. Remove three locknuts (5), washers (3), capscrews (4), washers (3), and front skid plate (6) from front bumper (1). Discard locknuts (5). a. Front Skid Plate Removal INITIAL SETUP: TM 9-2320-387-24-2 10-98.4 Change 1 10-58.2. UNDERBODY PROTECTION KIT REPLACEMENT Applicable Models M1113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Four rubber washers (Appendix G, Item 363.1) Forty-six locknuts (Appendix G, Item 156) Manual References TM 9-2320-387-24P General Safety Instructions • Do not perform this procedure near fire, flames, or sparks. • Fuel tank must be supported during removal and installation. Maintenance Level Unit This task covers: a. Front Skid Plate Removal g. Fuel Tank Shield Installation b. Front Shield Removal h. Rear Shield Installation c. Intermediate Shield Removal i. Transfer Case Shield Installation d. Transfer Case Shield Removal j. Intermediate Shield Installation e. Rear Shield Removal k. Front Shield Installation f. Fuel Tank Shield Removal l. Front Skid Plate Installation