TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 1148 of 1555

I TM 9-2320-387-24-2 I--- 29-3. TRANSFER CASE REPAIR (Cont’d) 8. 9. 10. 11. 12. 13. 14. 15. 16. Rotate oil pickup tube (13) and oil screen (14) out of rear half-case (5) and pull pickup tube (13) out of oil pump inlet port (12). 17. Remove oil pump (15) from rear half-case (5). Remove snapring (1) from mainshaft assembly (2). Remove four capscrews (3) from rear retainer (4) and rear half-case (5). Prying on tabs of rear retainer (4), remove rear retainer (4) from rear half-case (5) and mainshaft (2). Remove two snaprings (6) and speedometer drive gear (7) from mainshaft assembly (2). Remove two capscrews (10) and washers (11) from rear half-case (5) and front half-case (17). NOTE Mark positions of long screws for installation. Remove two long screws (9) from front output end of rear half-case (5). Remove seven screws (8) from rear half-case (5). NOTE Use slots in half-cases when separating half-cases. Pry and remove rear half-case (5) from front half-case (17). Lay rear half-case (5) on bench with oil pump (15) up. CAUTION Mark position of oil pump to rear half-case before removal. Failure to do so may cause damage to equipment. 29-4