TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1136 of 1555
TM 9-2320-387-24-2 28- 19. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (Cont’d) 7. Determine correct apply pin to be used from table 28-3. NOTE l Apply pins are identified by the number of rings around small end of apply pins. l If necessary to change apply pin, refer to rear servo repair, para. 28-16. Table 28-3. Apply Pin Selection. a. If both flats are above gauge surface, use pin length #l. b. If one flat is above gauge surface, use pin length #2. c. If both flats are below gauge surface, rotate to side B. d. If both flats are above gauge surface, use pin length #3. e. If one flat is above gauge surface, use pin length #4. f. If both flats are below gauge surface, rotate to side C. g. If both flats are above gauge surface, use pin length #5. h. If one flat is above gauge surface, use pin length #6. i. If both flats are below gauge surface, use pin length #7. 8. Remove checking tool and gauge pin. CHECKING TOOL \ GAUGE PIN GAUGE PIN --if? B cl A &ES ROTATE TO SlDE C #4 ROTATE TO SIDE B 7 PIN LENGTH 3.468-3.474 IN. (88.08-88.23 MM) 6 3.440-3.446 IN. (87.37-87.52 MM) 5 3.412-3.418 IN. (86.66-86.8 1 MM) 4 3.384-3.390 IN. (85.95-86.10 MM) 3 3.356-3.362 IN. (85.24-85.39 MM) m 2 3.328-3.334 IN. (84.53-84.68 MM) 1 . 3.300-3.306 IN. (83.82-83.97 MM) 28-85