TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1129 of 1555
28-78 Change 1 TM 9-2320-387-24-2 28-19. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (Cont’d) NOTE • Soak all clutch plates in transmission fluid (Dexron ® III) for at least three minutes before assembly. • Wave plate is used on 1997-1998 transmissions only. 1. Install wave plate (5), four clutch plates (3), clutch plate assemblies (6), and backing plate (2) on transmission case (4) starting with clutch plate (3), then alternating clutch plate assemblies (6) with clutch plates (3) and ending with flat side of backing plate (2) facing down. 2. Secure backing plate (2) to transmission case (4) with snapring (1). Position snapring gap at nine o’clock position. 3. Measure gap between snapring (1) and backing plate (2). Gap should be 0.040-0.107 in. (1.02-2.72 mm). e. Intermediate Clutch Assembly Installation 1995-1996 MODELS 1997-1998 MODELS 6