TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1125 of 1555
TM 9-2320-387-24-2 28-19. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (Cont’d) 1 b. Center Support Assembly Installation 1 1. Install thrust washer (21 and center support (1) in gear unit (3). 2. Install gear unit installer/remover and slide hammer to hold assembly together. c. Gear Unit Assembly Installation 1. 2. 3. 4. 5. 28-74 Install selective thrust washer (5) in transmission case (6) with smooth side of thrust washer (5) facing up. Position rear band (4) on transmission case (6) with flat end in notch and tab aligned with servo pin hole. NOTE Do not confuse center support spacer (0.040 in. (1.016 mm) thick and both sides flat>with either center support snapring (beveled on one side) or intermediate clutch backing plate snapring (0.093 in. (2.362 mm) thick and both sides flat). Install center support spacer (11) on fourth snapring groove (12) in transmission case (6) and position spacer gap at nine o’clock position. Coat thrust washer (10) with petrolatum and install over output shaft (9) onto gear unit (31, ensuring four tabs align with holes on gear unit (3). Align bolt hole (8) in center support (1) with bolt hole in transmission case (6).