TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1099 of 1555
TM 9-2320-387-24-2 28-13. TURBINE SHAFT AND OVERDRIVE CARRIER ASSEMBLY REPAIR (Cont’d) Eerrun ClutchAssemblv 1 1. 2. 3. 4. 5. CAUTION All transmission parts must be lubricated with clean transmission fluid (Dexron@ III) before assembly. Foreign material will cause transmission damage. Install piston (6) on clutch housing (7) and rotate piston (6) while seating in housing (7). Using spring compressor and adapter, install spring and retainer assembly (5) on housing (7) and secure with snapring (4). Starting with clutch plate (81, install three clutch plates (8) alternately with clutch plate assemblies (3) in housing (7). Install backing plate (2) over clutch plate assembly (3) and secure with snapring (1). Measure gap between snapring (1) and backing plate (2). Gap should be 0.033-0.094 in. (0.838-2.388 mm>. If not, check assembly of clutch plate pack (8) or replace clutch plate pack (8). 28-50