TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1065 of 1555
TM 9-2320-387-24-2 28-4. TORQUE CONVERTER MAINTENANCE This taskcovers: a. Cleaning INITIAL SETUP: Manual References TM 9-2320-387-24P Equipment Condition ?kansmission disassembled into subassemblies (para. 28-3). b. Inspection Maintenance Level General support NOTE Have drainage container ready to catch fluid. 1. Drain fluid from torque converter (1). Replace torque converter (11 if fluid is contaminated or abnormal looseness or noises were recorded during torque converter removal (para. 28-31. 2. Clean exterior of torque converter (1) in accordance with para. 2-14. rb. inspection ] 1. 2. 3. 4. 5. NOTE For general inspection instructions, refer to para. 2-15. Inspect torque converter hub (2) for damage. Replace torque converter (11 if hub (2) is damaged. Inspect torque converter (1) for proper operation by manually rotating splined inner race (3) in both directions. The splined inner race (3) should turn freely in clockwise direction, but not turn or be very difficult to turn in counterclockwise direction. Replace torque converter (1) if it does not operate properly. Inspect torque converter (1) for damaged or leaking seams and welds. Replace torque converter (1) if damaged. Inspect torque converter pilot (5) for damage. Replace torque converter (1) if damaged. Inspect threaded holes (4) for damage. Repair with thread repair inserts. If unable to repair threaded holes (41, replace torque converter (1). 28-20