TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1053 of 1555
28-8 Change 1 TM 9-2320-387-24-2 28-3. TRANSMISSION DISASSEMBLY INTO SUBASSEMBLIES (Cont’d) 1. Position transmission (1) so oil pan surface faces up. 2. Disconnect wiring harness (6) from PWM solenoid (7), pressure control solenoid (8), transmission fluid pressure switch (2), 2-3 shift solenoid (5), 1-2 shift solenoid (4), and connector (3). NOTE Capscrews are different lengths. Record location of each capscrew for installation. 3. Remove two capscrews (9), wiring harness clips (10), and harness (6) from control valve assembly (14). 4. Remove six capscrews (15) and transmission fluid pressure switch (16) from control valve assembly (14). 5. Remove capscrew (11), clip (12), and lube pipe (13) from control valve assembly (14). 6. Remove two capscrews (18) and spring and roller assembly (17) from control valve assembly (14). 7. Remove seventeen capscrews (21) and control valve assembly (14) from transmission (1). CAUTION Do not use magnets or any magnetized tools to remove checkballs. Some checkballs are metal and, if magnetized, will pick up debris from oil and cause malfunction of transmission. NOTE Record locations of checkballs for assembly. 8. Remove eight checkballs (19) from transmission (1). 9. Remove screen (20) from transmission (1). e.1. Control Valve Assembly Removal (1997-1998) 1 2 3 4 5 6 7 8