TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 1036 of 1555
TM9-2320-387-24-2 I 27-3. BODY WIRING HARNESS REPLACEMENT (Cont’d) I 48. 49. 50. 51. 52. 53. 54. 55. 56. 57. 58. Connect wiring harness connector (8) to sensor (6). Connect connectors 497/498 (7) and 495/496 (9) to output and input speed sensors (4) and (10). Install two capscrews (l), washers (21, clamps (3), and nuts (5) on sensors (4) and (10). Connect two leads (16) to transfer case switch leads (15) on transfer case (14). Secure speedometer cable (13) and harness (12) with tiedown strap (11). Connect harness connector (17) to TCM (18). NOTE Perform step 54 for Ml114 models only. Install winch cables (23) and harness (24) on body (22) with six clamps (201, four screws (21), and five tiedown straps (19). NOTE Perform step 55 for Ml113 models only. Perform steps 56 and 57 for Ml114 models only. Install coverplate (26) and bracket (34) on battery box (30) and B-beam (27) with two washers (35~ capscrews (361, washers (291, nuts (281, washers (31), lockwashers (321, and capscrews (33) and (25). Install cover-plate (37) on battery box (30) with two washers (381, lockwashers (39), and capscrews (40). Install cover-plate (37) on B-beam (27) with two capscrews (41). Connect two harness leads (42) to circuit breaker (43). 27-30