TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 987 of 1205
TM 9-2320-387-24-1 7-6 Change 1 7-3. SERVICE BRAKE PAD MAINTENANCE This task covers: a. Removal c. Installation b. Cleaning and Inspection Manual References TM 9-2320-387-24P Equipment Condition Brake protection guards removed (para. 7-11). General Safety Instructions Ensure brake pads are installed with linings facing rotor. Maintenance Level Unit a. Removal CAUTION Caliper must be supported during removal to prevent damage to brake hose. NOTE Perform steps 1 and 2 for right side. Perform steps 3, 4, and 5 for left side. 1. Using crowfoot, remove two capscrews (6), washers (5), clamp (6.1), caliper (3), and yoke (4) from adapter (2). NOTE Note positioning of brake pad surfaces for installation. 2. Remove two brake pads (1) from adapter (2). 3. Remove six capscrews (10), two-piece lockwashers (9), and halfshaft (8) from rotor (7). Discard two-piece lockwashers (9). 4. Install two capscrews (10) to hold rotor (7). NOTE Note positioning of brake pad surfaces for installation. 5. Remove two brake pads (1) from adapter (2). INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) C-clamp (Appendix B, Item 153) Special Tools Crowfoot, 14-mm (Appendix B, Item 141) Materials/Parts Grease (Appendix C, Item 34) Sealing compound (Appendix C, Item 63) Six two-piece lockwashers (Appendix G, Item 240.1)