TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 964 of 1205
1. Remove cotter pin (7), slotted nut (6), and washer (5) from radius rod (4) and geared hub (8). Discard cotter pin (7). 2. Remove locknut (9), washer (2), capscrew (1), washer (2), and radius rod (4) from bracket (3) and geared hub (8). Discard locknut (9). 1. Install radius rod (4) on bracket (3) with washer (2), capscrew (1), washer (2), and locknut (9). CAUTION Do not loosen slotted nut to install cotter pin. Doing this may result in damage to equipment. 2. Install radius rod (4) on geared hub (8) with washer (5) and slotted nut (6). Tighten slotted nut (6) to 70 lb-ft (95 N•m). Install cotter pin (7). 3. Tighten locknut (9) to 260 lb-ft (353 N•m). b. Installation a. Removal 6-22. RADIUS ROD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Cotter pin (Appendix G, Item 34) Locknut (Appendix G, Item 130) TM 9-2320-387-24-1 Change 1 6-51 Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Wheel removed (para. 8-3). Maintenance Level Unit FOLLOW-ON TASKS: • Lubricate radius rod (TM 9-2320-387-10). • Install wheel (para. 8-3). • Adjust rear wheel toe-out alignment (para. 8-10). 2 3 1 4 5 6 7 9 2 8