TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download

Page 955 of 1205

TM$2320-387-24-1 I 6-16. FRONT GEARED HUB VENT LINE REPLACEMENT 1 This taskcovers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 11 nlanual References TM 9-2320-387-24P Equipment Condition Wheel removed (para. 8-3). MaintenanceLevel Unit 1 a. Removal 1 NOTE The replacement procedure for each front geared hub vent line is basically the same. This procedure covers the right front geared hub vent line. Mark clamp position before loosening to ensure clamps are properly positioned during installation. 1. Remove four screws (7) and clamps (3) from frame (131, front control arm (21, and geared hub (8). 2. Loosen two clamps (6) and disconnect front vent line (4) from elbow (5) and tee fitting (1). 3. Remove nut (121, washer (ll), screw (lo), clamp (91, and front vent line (4) from control arm (2). b. Installation _ 1. Install clamp (9) and front vent line (4) on control arm (2) with screw (lo), washer (111, and nut (12). 2. Connect vent line (4) to elbow (5) and tee fitting (1) with two clamps (6). 3. Install vent line (4) and four clamps (3) on geared hub W, control arm (21, and frame (13) with four screws (7). 6-42