TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 950 of 1205
6-12. GEARED HUB SPINDLE BEARING ADJUSTMENT (Cont'd) FOLLOW-ON TASK: Install wheel (para. 8-3). TM 9-2320-387-24-1 Change 1 6-37 10. Clean sealing surfaces on geared hub (6) and steering arm cover (9). Apply anaerobic sealant to steering arm cover (9) and install steering arm cover (9) on geared hub (6). 11. Apply sealing compound to threads of four capscrews (11) and install steering arm cover (9) on geared hub (6) with four washers (10) and capscrews (11). Tighten capscrews (11) to 65 lb-ft (88 N•m). 12. Remove fill plug (7) and washer (8) from geared hub (6). 13. Fill geared hub (6) to proper oil level (para. 2-12). 14. Install washer (8) and fill plug (7) on geared hub (6). Tighten fill plug (7) to 8-13 lb-ft (11-18 N•m). CAUTION When installing steering arm cover, ensure seal in cover is aligned on spindle extension. Damage to seal will result if not aligned. NOTE Immediately install steering arm cover after application of sealant. 6 7 8 6 11 10 9