Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download

Page 938 of 1205

6-9. GEARED HUB REPLACEMENT (Cont'd) TM 9-2320-387-24-1 Change 1 6-25 NOTE Ensure outer capscrews are installed from top down and inner capscrews are installed from bottom up. 8. Secure lower ball joint (4) to lower control arm (16) with four washers (13), capscrews (14), washers (13), and locknuts (17). Tighten locknuts (17) to 60 lb-ft (81 N•m). CAUTION Do not loosen slotted nut to install cotter pin. Doing this may result in damage to equipment. 9. Tighten slotted nut (2) on lower ball joint (4) to 73 lb-ft (99 N•m) and install cotter pin (1). 1 4.1 4.2 4.3 3 4 2 VISE 5 6 7 8 3 9 10 11 12 2 13 4 14 15 16 13 17 18 19 20 21