TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 931 of 1205
6-7. HALFSHAFT MAINTENANCE (Cont’d) TM 9-2320-387-24-1 NOTE Adhere spider assembly with lithium grease before installing on shaft. 9. Align splines of spider assembly (4) with spline on shaft (5). Use press to install spider assembly (4) on shaft (5) until spider assembly (4) seats into place. 10. Install retainer ring (3) in upper groove of shaft (5). 11. Pack inner joint (1) with lithium grease. 12. Install insert (2) on inner joint (1). 13. Install inner joint (1) and insert (2) on spider assembly (4) and shaft (5). 14. Move inner boot (6) on shaft (5) until inner boot (6) seats in groove of shaft (5). 15. Secure inner boot (6) on shaft (5) with clamp (8). 16. Install inner boot (6) on inner joint (1). Ensure boot (6) seats in groove of inner joint (1). 17. Secure inner boot (6) on inner joint (1) with clamp (7). 1 2 3 4 5 6 7 8 1. Install halfshaft (18) into geared hub (13). 2. Apply sealing compound to halfshaft retaining capscrew (15) and install halfshaft (18) on geared hub (13) with lockwasher (14) and halfshaft retaining capscrew (15). Tighten halfshaft retaining capscrew (15) to 37 lb-ft (50 N•m). 3. Install washer (16) and access plug (17) into geared hub (13). Tighten access plug (17) to 8-13 lb-ft (11-18 N•m). e. Installation 6-18 Change 1