TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download

Page 915 of 1205

TM 9-2320-387-24-l 6-2. FRONT PROPELLER SHAFT ASSEMBLY MAINTENANCE This task covers: a. Removal c. Installation b. Inspection INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Cotter pin (Appendix G, Item 33) Manual References TM 9-2320-387-10 TM 9-2320-387-24P MaintenanceLevel Unit NOTE Propeller shaft bearing caps should be taped together to prevent loss of bearings. I[ 1. Remove four capscrews (3) and two bearing straps (2) from front propeller shaft assembly (4) and differential pinion yoke (1). 2. Remove four nuts (71, washers (81, and two U-bolts (11) from front propeller shaft assembly (4) and transfer case output yoke (9). 3. Remove cotter pin (14), washer (131, and transfer case shift rod (12) from transfer case shifi lever (6). Discard cotter pin (14). 4. Remove two nuts (E), washers (161, capscrews (18), washers (161, and center bearing (17) from engine mount (19). 5. Move front propeller shaft assembly (4) forward, then rearward, over top of transfer case (5) and exhaust pipe (101, and remove front propeller shaft assembly (4). 1. Inspect driveshaft (21) and coupling shaft (22) for cracks and damage. Replace either if cracked or damaged (para. 6-3). 2. Inspect grease fittings (23) and universal joints (20) for serviceability. Replace universal joints (20) or grease fittings (23) if unserviceable (para. 6-3). 3. Inspect center bearing (17) for roughness or damage. Replace coupling shaft (22) if center bearing (17) is rough or damaged (para. 6-3). 6-2