TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 908 of 1205
TM 9-2320-387-24-l 1 5-l 7. SPEEDOMETER DRIVEN GEAR REPLACEMENT I Tbii task covers: a. Removal INITIAL SETUP: b. Installation Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Special Tools Materials/Parts O-ring seal (Appendix G, Item 284) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Mirror, inspection (Appendix B, Item 84) Maintenance Level Unit p7iGz-l 1. Disconnect flex driveshaft (1) from correction adapter (2). 2. Loosen nut (3) and remove correction adapter (2) from pinion adapter (6). 3. Remove capscrew (4) and clamp (5) from pinion adapter (61 and transfer case (8). 4. Pull pinion adapter (6) out of transfer case (8). 5. Remove O-ring seal (7) from pinion adapter (6). Discard O-ring seal (7). 6. Remove driven gear (9) from transfer case (8). b. Installation 1. Install O-ring seal (7) on pinion adapter (6). NOTE Note number stamped on driven gear. 2. Install driven gear (9) into pinion adapter (6). NOTE Numbers on pinion adapter represent numbers stamped on driven gear. When installing adapter, numbers on adapter must match numbers on transfer case housing. 3. Install and align pinion adapter (6) into transfer case (8) with clamp (5) and capscrew (4). Tighten capscrew (4) to 15 lb-R (20 Nem). 4. Install correction adapter (2) on pinion adapter (6) and tighten nut (3). 5. Connect flex driveshaft (1) to correction adapter (2). 5-34