TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 900 of 1205
TM 9-2320-387-24-l I 5-l 1. SEALED LOWER CONVERTER HOUSING COVER MAINTENANCE This taskcovers: a. Removal b. Inspection c. Installation n INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) bIaterials/Parts Gasket (Appendix G, Item 57) General !%fetp Instructions Adhesive (Appendix C, Item 61 Drycleaning solvent is flammable and will not be Drycleaning solvent (Appendix C, Item 26) used near an open flame. Manual References TM 9-2320-387-24P hlaintenanceLevel Unit EquipmentCondition l Exhaust pipe removed (para. 3-50). l Sealed upper converter housing cover removed (para. 5-12). 1. Remove three capscrews (5) and converter housing cover (4) from transmission (2). 2. Remove gasket (3) from converter housing cover (4). Discard gasket (3). b. Inspection 1. Inspect converter housing cover (4) for pitting, cracking, and excessive wear. Replace if pitted, cracked, or excessively worn. WARNING Drycleaning solvent is flammable and will not be used near an open flame. A fire extinguisher will be kept nearby when the solvent is used. Use only in well-ventilated places. Failure to do this may result in injury to personnel and/or damage to equipment. 2. Remove gasketmaterial and sealant from converter housing cover (4) and transmission (2) with drycleaning solvent. c. Installation NOTE Gasket must be bent over edge of converter housing cover to ensure gasket seats properly. 1. Apply adhesive to gasket (3) and install on converter housing cover (4). CAUTION Ensure converter housing cover is seated on oil pan flange to prevent converter housing cover from hitting flywheel and damaging converter housing cover. 2. Install converter housing cover (4) on flange (1) and transmission (2) with three capscrews (5). 5-26