TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 874 of 1205
I TM 9-2320-387-24-l 1 4-80. WIRING HARNESS CONNECTOR REPAIR (Cont’d) I e. ReceptacleAssemblyRepair NOTE Refer to TB SIG-222 for soldering instructions. 1. Strip cable insulation (1) to depth of solder wells (5) on inserts (61. 2. Slide cable ends (3) through grommet retaining nut (2) and grommet (41. 3. Place cable ends (31 into solder wells (5) and solder. 4. Slide grommet (4) over inserts (5) and press into receptacle (71 until seated. 5. Screw grommet retaining nut (2) into receptacle (7) until seated. P 7 m m m m IProtective Control Box Lower Cannon Plug Assembly Repair 1 1. Strip cable insulation (8) to depth of solder wells (16) on inserts (14). 2. Slide cable ends (101 through grommet retaining nut (91 and grommet (11). 3. Slide insulation sleeving (17) over lead 67A (181. 4. Place cable ends (10) into solder wells (16) and solder. NOTE Ensure insulation sleeving passes through grommet to provide a water-tight fit. 5. Slide insulation sleeving (171 up to solder well end (151, and heat-shrink insulation sleeving (171. 6. Slide grommet (11) over inserts (14) and press into shell assembly (12) and coupling nut (131 until seated. 7. Install grommet retaining nut (9) into shell assembly (12) until seated. FOLLOW-ON TASK: Connect battery ground cables (para. 4-681. 4-148