TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download

Page 862 of 1205

TM 9-2320-387-24-l 4-77. WINCH POWER CABLE REPLACEMENT (Cont’d) 1 c. Rear Power Cable Removal 1 1. Remove capscrew (8), lockwasher (7), ground lead (61, and lead 7 (5) from winch (41. Discard lockwasher (71. 2. Remove nut (1) and lead 6W (3) from solenoid (2). 3. Remove nine screws (131, clamps (121, five tiedown straps (111, harness (lo), and leads 7 (51 and 6W (3) from body (9). Discard tiedown straps (11). 4. Removenut (181, lockwasher (191, washer (201, and lead 6W (3) from buss bar (17). Discard lockwasher (19). 5. Remove nut (151, lockwasher (141, and lead 7 (5) from capscrew (16). Discard lockwasher (141. d. Rear Power Cable installation 1. Install lead 7 (5) on capscrew (16) with lockwasher (14) and nut (15). Tighten nut (151 to 15-20 lb-R (20-27 N-m). 2. Install lead 6W (3) on buss bar (171 with washer (201, lockwasher (191, and nut (18). Tighten nut (181 to 15-20 lb-R (20-27 N-m). 3. Install leads 7 (5),6W (31, and harness (10) on body (9) with nine clamps (121, screws U3), and five tiedown straps (11). 4. Install lead 6W (3) on solenoid (2) with nut (1). 5. Install lead 7 (5) and ground lead (6) on winch (4) with lockwasher (7) and capscrew (81. 4-136