TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 842 of 1205
TM 9-2320-387-24-l 4-69. POWER FEED-THROUGH STUD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools ?&era1 mechanic’s tool kit: automotive (Appendix B, Item 1) Maintena.nce and repair shop equipment: automotive (Appendix B, Item 2) MaterialsParts Lockwasher (Appendix G, Item 212) Sealing compound (Appendix C, Item 64) Manual References TM 9-2320-387-24P Equipment Condition Buss bar removed (para. 4-711. Maintenance Level Unit 1. Slide rubber boot (5) from power feed-through stud (9) and remove nut (11, lockwasher (2), washer (31, lead 6B/6C (41, and starter cable (6) from feed-through stud (9). Discard lo&washer (2). 2. Remove nut (7) and feed-through stud (9) from battery box (8). b. Installation 1. Install power feed-through stud (9) on battery box (8) with nut (‘7). 2. Install starter cable (6) and lead 6B/6C (4) on feed-through stud (9) with washer (3), lockwasher (2), and nut (1). Tighten nut (1) to 18-22 lb-R (24-30 N-m). 3. Apply sealing compound to feed-through stud (9), starter cable (61, and lead 6B/6C (41, coating all exposed metallic surfaces. 4. Slide rubber boot (5) over feed-through stud (9). 4-116