Sign up to sell your inventory with NSN Lookup

TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download

Page 768 of 1205

TM 9-2320-387-24-l 4-20. WAIT-TO-START LAMP REPLACEMENT I This task covers: a. Removal h. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition l Battery ground cables disconnected (para. 4-68). l Instrument cluster removed (para. 4-14). Maintenance Level unit NOTE Prior to removal, tag leads and note position for instaIIation. pIYiizq - 1. Loosen nut (14) and lower steering column (7). 2. Remove cannon plug (16) from main light switch (15). 3. Remove two capscrews (171, washers (181, nuts (201, and washers (18) from instrument panel (6) and body (19). 4. Remove nut (22) and screw (23) from hand throttle bracket (21) and instrument panel (6). 5. Remove nut (131, washer (111, capscrew (101, and washer (11) from instrument panel (61, hand throttle bracket (211, and steering column bracket (12). 6. Remove screw (8) from instrument panel (6) and cowl (9). 7. PuII instrument panel (6) away from body (19). 8. Remove two screws (5) from wait-to-start lamp (4) and instrument panel (6). 9. Disconnect leads 571(2) and 27 (3) from wiring harness (1). 10. Remove wait-to-start lamp (4). -1 1. 2. 3. 4. 5. 6. Connect leads 571(2) and 27 (3) to wiring harness (1). InstaIl wait-to-start lamp (4) on instrument panel (6) with two screws (5). Install instrument panel (6) on cowl (9) with screw (8). Install instrument panel (6) and hand throttle bracket (21) on steering column bracket (12) with washer (111, capscrew (lo), washer (ll), and nut (13). Install hand throttle bracket (21) on instrument panel (6) with screw (23) and nut (22). Install instrument panel (6) on body (19) with two washers (181, capscrews (171, washers (18), and nuts (20). 7. Install cannon plug (16) on main light switch (15). 8. Raise steering column (7) and tighten nut (14) to 31 lb-R (42 N-m). 4-42