TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 747 of 1205
TM 9-2320-387-24-1 4-20 Change 1 Section II. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE 4-9. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE TASK SUMMARY TASK PAGE PARA. PROCEDURES NO. 4-10. Rotary Switch Replacement 4-20 4-11. Starter Replacement 4-22 4-12. Circuit Breaker Replacement 4-26 Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Battery ground cables disconnected (para. 4-68). Maintenance Level Unit a. Removal 1. Remove screw (8), lockwasher (7), and switch lever (6) from switch shaft (9). Discard lockwasher (7). 2. Remove nut (5) and lockwasher (4) from switch (2) and instrument panel (3). Discard lockwasher (4). 3. Push switch (2) out of hole in panel (3). 4. Disconnect three electrical leads 11A (1), 14A (10), and 29A (11) from switch (2). b. Installation 1. Connect three electrical leads 11A (1), 14A (10), and 29A (11) to switch (2). 2. Install switch (2) into hole in instrument panel (3). 3. Install lockwasher (4) and nut (5) on switch (2). 4. Place switch lever (6) on switch shaft (9) to ENGINE STOP position. 5. Secure lever (6) on switch shaft (9) with lockwasher (7) and screw (8). NOTE Prior to removal, tag leads and note position of lever for installation. INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Lockwasher (Appendix G, Item 208) Lockwasher (Appendix G, Item 207) This task covers: a. Removal b. Installation 4-10. ROTARY SWITCH REPLACEMENT