TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 662 of 1205
TM 9-2320-387-24-l 3-50. EXHAUST PIPE REPLACEMENT I This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 21 Materials/Parts Equipment Condition Right rear heat shield removed (para. 3-58). General Safety Instructions Do not touch hot exhaust system components with bare hands. Three locknuts (Appendix G, Item 157) Gasket (Appendix G, Item 55) Maintenance Level Unit >Ianual References TM 9-2320-387-10 TM 9-2320-387-24P WARNING Do not touch hot exhaust system components with bare hands. Severe injury may result. 1 a. Removal 1 1. Remove two clamps (12) and heat shield (111 from exhaust pipe (3). 2. Remove three locknuts (5), washers (4), capscrews (7), washers (41, and exhaust pipe (3) from catalytic converter (2). DicLard locknuts (5). 3. Remove two capscrews (8), washers (91, flange (lo), and exhaust pipe (31 from wastegate housing (1). 4. Remove and discard gasket (6). r!zzzzq 1. Install flange (10) and exhaust pipe (3) on wastegate housing (1) with two washers (9) and capscrews (8). 2. Install gasket (6) and exhaust pipe (3) on catalytic converter (2) with three washers (41, capscrews (7), washers (41, and locknuts (5). Tighten locknuts (5) to 26 lb-R (35 N-m). 3. Install heat shield (11) on exhaust pipe (3) with two clamps (12). 3-94