TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 620 of 1205
TM9-2320-387-24-l 3-26. FUEL TANK SUPPLY AND RETURN LINES REPLACEMENT This task covers: a. Removal b. Installation I -- INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts ‘ItKolocknuts (Appendix G, Item 109) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Engine right splash shield removed (para. 10-24). General Safety Instructions Do not perform this procedure near fire, flames, or sparks. Maintenance Level unit WARNING Diesel fuel is highly flammable. Do not perform this procedure near fire, flames, or sparks. Severe injury or death may result. [I CAUTION * Cover or plug all open hoses and connections immediately after disconnection to prevent contamination. Remove all plugs prior to connection. NOTE Have drainage container ready to catch fuel. 1. Loosen four clamps (71 and disconnect hoses (61from fuel tank return and supply lines (8). 2. Remove two locknuts (11, capscrews (51, washers (41, clamps (31, and return and supply lines (8) from front body bracket (2) and rear body bracket (101. Discard locknuts (1). 3. Remove three clips (9) from fuel supply and return lines (81. )I 1. Install return and supply lines (8) on front body bracket (2) and rear body bracket (10) with two clamps (3), washers (41, capscrews (51, and locknuts (11. 2. Connect supply and return lines (8) to four hoses (6) and tighten clamps (7). 3. Secure fuel supply and return lines (8) together with three clips (91. 3-52