TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 574 of 1205
TM9-2320-387-24-l 3-5. ENGINE Of1 SERVICE This task covers: a. Oil Draining b. Filter Removal c. Filter Installation d. Oil Replenishing INiTlAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Oil filter (Appendix G, Item 254) Lubricating oil (Appendix C, Item 44) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Hood raised and secured (TM 9-2320-387-10X General Safety Instructions Do not drain oil when engine is hot. MaintenanceLevel Unit a. Oil Draining WARNING Do not drain oil when engine is hot. Severe injury to personnel may result. NOTE l Park vehicle on a firm, level surface. l Have drainage container ready to catch oil. 1. Remove drainplug (5) and gasket (4) from oil pan (3). Allow oil to drain completely. 2. Install gasket (4) and drainplug (5) on oil pan (3). Tighten drainplug (5) to 20 lb-R (27 Nom). b. Filter Removal NOTE Have drainage container ready to catch oil. Remove oil filter (1) from filter adapter (2). Discard filter (1). c. Filter Installation 1. Apply a light coat of oil to filter gasket prior to installation. 2. Install oil filter (1) on oil filter adapter (2) until gasket contacts filter adapter (2). Tighten an additional l/2-3/4 turn by hand. d. Oil Replenishing CAUTION Install a non-vented filler cap only. An incorrect filler cap will not seal properly, allowing water to enter and damage engine. 1. Remove filler cap (6) from filler tube (7). Fill with oil according to TM 9-2320-387-10. 2. Install filler cap (6) on filler tube (7). 3-6