TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 565 of 1205
TM 9-2320-387-24-l Table 2-6. STE IKE-R GO-Chain Tests. INDICATES VTM IS PROPERLY I= 1 FORTESTS CONNECTED AND READY GO-CHAIN INDICATES GO CONDiTlON AFTER CONFIDENCE TESTS NOTE Perform all GO steps until a NO-GO condition exists, then perform the NO-GO step indicated. 1 V CAUTION I l Do not connect or disconnect the VTM while the vehicle is running. l Connect DCA cable to the VTM before connecting to the diagnostic connector. CONNECT VTM TO VEHICLE DIAGNOSTTC CONNECTOR: l PULL OFF the VTM power switch. l Connect DCA cable to the VTM. l Connect DCA cable to the vehicle. l PUSH ON the VTM power switch. l Verify that the display indicates .8.8.8.8 for opproximotely 2 seconds and then changes to - - - -. l Does the VTM display .8.8.8.8 and then change to - - - - ? II I 1 l Proceed to step 3. 1 1 l Proceed to following page. -27’ I J J AFTER 2 SECONDS 2-519