TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 546 of 1205
TM 9-2320-387-24-l 1 2-46. STEACE-R TEST PROCEDURES (Cont’d) STARTER CURRENT AVERAGE TEST #71 Description: This procedure measures the average starter current in the 0 - 1,000 amps range. Test requires DCA hookup only. Typical Applications: Control Functions: Check starter current. 01, 02,03.04,06 Test Procedure: 1. Disconnect fuel solenoid wire 54A to prevent starting. 2. Set TEST SELECT switch to 71. 3. Press and hold TEST button until CAL appears on display. 4. Release TEST button and wait for offset value to appear on display. If offset is within -150 to 150, proceed. ff not, go to DCA Troubleshooting Procedure. 5. Press and release TEST button. 6. Crank engine. 7. Observe the displayed starter Current. Pre-Test Procedures: Run confidence test. Possible Error Messages: E005 Offset not performed. 2-500