TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 535 of 1205
TM 9-2320-387-24-l 1 2-46. STEACE-F? TEST PROCEDURES 1 This paragraph will be helpful when using the STE/ICE-R to answer diagnostic questions. Use this paragraph as a reference if you need additional information about a specific test. This paragraph contains information such as possible errors, test procedures, control codes, and additional notes as necessary. The following chart will help you find the test you need. The STE/ICE-R setup and internal checks (Test No. GO1 , page 2-519) must be performed prior to performing tests. A complete description and operation of the STEXE-R is found on page 2-509. See TM 9-4910-571-12&P for additional information. TEST NAME TEST # PAGE # ENGINE RPM (AVERAGE) POWER TEST (RPM/SEC) POWER TEST (PERCENT) COMPRESSION UNBALANCE TEST FUEL SUPPLY PRESSURE (PSI) PRESSURE (PSI) 0 TO 1,000 BAITERY VOLTAGE STARTER MOTOR VOLTAGE STARTER NEGATIVE CABLE VOLTAGE DROP STARTER SOLENOID VOLTS STARTERCURRENTAVERAGE CURRENT FIRST PEAK BAl-l-ERY INTERNAL RESISTANCE STARTER CIRCUIT RESISTANCE BATTERY RESISTANCE CHANGE BATTERY CURRENT DC VOLTAGE 0 TO 45 VOLTS DC CURRENT 0 TO 1,500 AMPS 10 12 13 14 24 50 67 68 69 70 71 72 73 74 75 80 89 90 .. _^ 2-490 2-491 2-492 2-493 2-494 2-495 2-496 2-497 2-498 2-499 2-500 2-501 2-502 2-503 2-504 2-505 2-506 2-507 RESISTANCE AND CONTINUITY 0 TO 4,500 OhMS g, 2-508 - 2-489