TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 319 of 1205
TM 9-2320-387-24-l REFERENCE INFORMATION Don’t forget that your vehicle batteries are disconnected, so you can’t run the SLUICE-R from the DCA. You have to use the power cable and connect directly to the batteries. When the resistance is too high for STEXE-R to measure, as in the case of an open circuit, STEACE-R displays .9.9.9.9. Replace rotary switch (para. 4-10). Dont forget that your vehicle batteries are disconnected, so you can’t run the STMCE-R from the DCA. You have to use the power cable and connect directly to the batteries. When the resistance is too high for SLUICE-R to measure, as in the case of an open circuit, STUICE-R displays .9.9.9.9. Replace rotary switch (para. 4-10). STARTER CIRCUIT RESISTANCE AND CONTINUITY 04,500 OHMS STfYlCE-R TEST 91 I 1. Connect RED clip and BLACK clip to the indicated test points in the question. RED to the first, BUCK to the second. 2. Start Test 91,0-4.500 Ohms. 3. Displayed reading is in ohms. Less than 5 is continuity. If the resistance is over 4,500 ohms, STEXE-R displays .9.9.9.9. CONTINUITY (RESISTANCE) MULTIMETER 1. Set the voltmeter to an ohms scale of about 1,000 ohms. 2. Connect the RED and BLACK leads to the connections stated in the question. 3. Be sure to read the correct scale. Less than 5 ohms indicates continuity. For an open circuit, the meter should peg full scale (needle all the way to the left). REAR OF ROTARY SWtTCH 2-263