TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 230 of 1205
REFERENCE INFORMATION CONTINUITY (RESISTANCE) MULTIMETER 1. Set the voltmeter to an ohms scale of about 1,000 ohms. 2. Connect the RED and BLACK leads to the connections stated in the question. 3. Be sure to read the correct scale. Less than 5 ohms indicates continuity. For an open circuit, the meter should peg full scale (needle all the way to the left). Disconnect the four-way connector at the time-delay module and measure the voltage on wire 315D. I DC VOLTAGE O-45 VOLTS STEIICE-R TEST 89 1. Connect RED clip to the indicated test point, BLACK clip to negative or ground. 2. Start Test 89. DC Volts. 3. Displayed reading is in volts. r ’ TM 9-2320-387-24-l ENGINE COOLING RESISTANCE AND CONTINUITY 04500 OHMS STEIICE-R TEST 91 1. Connect RED clip and BLACK clip to the terminations indicated in the question. RED to the first, BLACK to the second. 2. Start Test 91,0-4.500 Ohms. 3. Displayed reading is in ohms. Less than 5 ohms is continuity. If the resistance is over 4,500 ohms, STUICE-R displays -9.9.9.9. NO STEP 2-l 73