TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1100 of 1205
I TM 9-23X-387-24-1 8-22. INTERMEDIATE STEERING SHAFT CLOSE-OFF AND RETAINER REPLACEMENT I This task covers: a. Removal b. Installation INITIAL SETUP: Tools %&era1 mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Personnel Required One mechanic One assistant Manual References TM 9-2320-387-24P Four locknuts (Appendix G, Item 109) Maintenance Level Locknut (Appendix G, Item 141) Unit NOTE Perform steps a.1 and b.2 only when replacing close-off retainer. Close-off may be replaced without disconnecting intermediate steering shaft. va.Removal) 1. Remove locknut (81, washer (91, capscrew (111, and washer (9) and disconnect intermediate steering shaft (10) from steering column (2). Discard locknut (8). 2. Remove four locknuts (12), washers (61, capscrews (5), and washers (6) from hand throttle bracket (71, close-off retainer (41, close-off (3), and cowl panel (1). Remove close-off retainer (4) and close-off (3) from steering shaft (10). Discard locknuts (12). b. Installation 1. Install close-off (3) and close-off retainer (4) on cowl panel (1) and hand throttle bracket (7) with four washers (61, capscrews (51, washers (61, and locknuts (12). Tighten locknuts (12) to 8 lb-ft (11 Nom). 2. Install intermediate steering shaft (10) through close-off (3) on steering column (2) with washer (91, capscrew (ll), washer (91, and locknut (8). Tighten locknut (8) to 40-50 lb-ft (54-68 N-m). 8-62