TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1088 of 1205
I TM 9-2320-387-24-l I 8- 18. STEERING COLUMN REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tool.5 General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Two locknuts (Appendix G, Item 116) Locknut (Appendix G, Item 152) Locknut (Appendix G, Item 141) Locknut (Appendix G, Item 156) Lockwasher (Appendix G, Item 205) Nut and lockwasher assembly (Appendix G, Item 250) Manual References TM 9-2320-387-24P EquipmentCondition l Steering wheel removed (para. 8-12). l Directional signal control removed (para. 4-63). Maintenance Level Unit 1 a. Removal 1 1. 2. 3. 4. 5. 6. Remove locknut (11, lockwasher (21, washer (31, and pin (5) from steering column (6) and mounting bracket (4). Discard lockwasher (2) and locknut (1). Remove nut and lo&washer assembly (171, screw (71, and ground wire 57C (8) from steering column (6). Discard nut and lockwasher assembly (17). Remove locknut (lo), washer (ll), capscrew (13), washer (ll), and two brackets (9) from steering column (6). Discard locknut (10). Disconnect lead 25A (21) from steering column (6). NOTE When performing step 5, temporarily install steering wheel and turn steering column to gain access to steering column inter- mediate shaft mounting hardware. Remove locknut (12), washer (141, capscrew (151, washer (14), and intermediate shaft (16) from steering column (6). Discard locknut (12). Remove two locknuts (201, washers (18), screws (191, washers (181, and steering column (6) from mounting bracket (4). Discard locknuts (20). 8-50