TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1082 of 1205
TM 9-2320-387-24-i 8-16. TIE ROD END REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: autom.otive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Puller kit (Appendix B, Item 157) hlaterials/Parts Cotter pin (Appendix G, Item 35) hlanual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Front of vehicle raised and supported (para. 8-2). hlaintenance Level Unit 1. Remove cotter pin (8), slotted nut (7), and washer (6) from tie rod end (4) and geared hub (5). Discard cotter pin (8). 2. Using puller, remove tie rod end (4) from geared hub (51. NOTE Note number of threads exposed on each tie rod end for installation, Approximately the same number of threads should be exposed on each tie rod end. 3. Loosen nut (91, capscrew (31, clamp (2), and tie rod end (4) from adjusting sleeve (1). b. Installation CAUTION Ensure clamp faces halfshaft or damage to equipment may result. 1. Install tie rod end (4) into sleeve (1) with clamp (21, capscrew (31, and nut (91. CAUTION Do not loosen slotted nut to install cotter pin. Doing this may result in damage to equipment. 2. Install tie rod end 70 lb-R (95 Nom). (4) on geared hub (5) with washer (6) and slotted nut (71. Tighten slotted nut (7) to 3. Install cotter pin (8) in slotted nut (7). a-44